Researchers at Northwestern University have developed a hybrid 3D printing process called direct ink additive lithography, or DIAL, that is designed to pattern thick, particle-filled inks with speed and resolution closer to light-based printing. The work, led by Pranav Kaarthik, was published in Science Advances.
DIAL addresses a trade-off between two established approaches. Digital light processing requires low-viscosity resins that scatter light only weakly, while direct ink writing can handle functional yield-stress inks but is slowed by filament deposition and constrained by nozzle diameter. The Northwestern team combined extrusion with projection rather than choosing one route.
For each layer, a slot die extrudes ink onto a substrate and a doctor blade spreads it into a sheet as thin as 25 microns. A 405-nanometer projector then moves over the sheet and crosslinks selected regions. Ink that is not exposed remains in place and acts as support. Because light passes only through a thin sheet, opaque and heavily filled inks can remain printable, according to the researchers. The projector's 50-micron pixel pitch sets the planar resolution.
Ryan Truby, the June and Donald Brewer Junior Professor of Materials Science and Engineering at Northwestern, said manufacturers have had to choose between the materials they need and the printing speed, resolution and scale they want. He said DIAL lays a foundation for eliminating that compromise.
Using a model ink made from a polyurethane-based resin thickened with fumed silica, the team printed a 60 mm by 40 mm log-pile structure in 30 minutes, compared with 124 minutes for direct ink writing. The process also produced fins about 150 microns thick. By rastering projection over overlaid ink sheets, the researchers made a multimaterial lattice four times the projector's illumination area.
The paper reports several demonstrators. The group printed interlocking chain mail with struts about 250 microns thick and produced 15 gyroid structural electrolyte lattices from an ionogel ink in a single 15-minute run. It also made hydrogel cell-culture inserts containing 0.5-mm-deep inverted pyramids. These examples show that DIAL can handle functional, particle-filled formulations and create porous or interlocking architectures.
The authors described their print times as conservative because tool changes had not been tuned for speed. They also noted that DIAL lacks the suction and peel forces associated with vat-based printing, which they said should make it easier to expand build area and volume. Truby said rebuilding American manufacturing will depend on new ways to make advanced materials, and that DIAL's ability to print many complex functional parts at once offers a path from the lab toward larger-volume manufacturing of architected materials for robotics, aerospace, healthcare and other applications.
Kaarthik and Truby are listed as coinventors on a U.S. provisional patent application. Funding came from the National Science Foundation, the Air Force Office of Scientific Research and Northwestern's McCormick School of Engineering.
