Electrical Equipment & Supplies

FastConvert Converter Gives School an Addressable Fire System Without Re-Cabling

Ingrid SolbergNovember 5, 20265 min read3 views

At a glance

  • A Stoke-on-Trent primary school converted its existing conventional fire wiring to an addressable loop with C-TEC's FastConvert, avoiding a full re-cable estimated at around £10,000.
  • North Road Academy in Stoke-on-Trent upgraded its fire system by converting existing conventional wiring into an addressable loop using C-TEC's FastConvert, rather than replacing the system. Installer W R Fire & Security says the approach avoided a full re-cable estimated at around £10,000 and saved roughly £3,500 on the project.
A cutaway illustration of a school corridor ceiling, where existing cabling links ceiling-mounted fire detection devices into a single loop connected to a wall-mounted control panel.

A primary school in Stoke-on-Trent has upgraded its fire detection system by converting the existing conventional wiring into an addressable loop rather than replacing the installation outright, using C-TEC's FastConvert zone converter.

North Road Academy, an Islamic primary school, had initially considered a complete replacement of its fire system. Following a site survey, specialist electrical company W R Fire & Security identified the potential to enhance the existing conventional system instead, converting it to an addressable system with FastConvert.

Three alternatives weighed

According to C-TEC's account of the project, three upgrade options were considered before FastConvert was selected:

  • A new conventional panel: this would have allowed zones to be separated out and additional zones created, but required extra cabling and would still have left the school with a conventional system limited to reporting zonal fire and fault information.
  • A full re-cable: ruled out on budget grounds, since it was estimated to add £10,000 in materials and additional labour, along with greater disruption and a longer installation timescale.
  • Converting the remaining six zones into loops: this would have added around a week to the installation for two engineers, plus additional cabling, materials and disruption, at an estimated extra cost of £3,000 to £4,000.

Reusing the existing wiring

C-TEC says FastConvert was the only option that avoided all three drawbacks at once: it reuses the existing wiring, delivers a genuine loop-based addressable system rather than a conventional one, and does so without the extra cost, labour or disruption.

In this installation, two radials were combined into a single loop, with a dedicated two-loop panel installed for FastConvert. The result is described as an open-protocol CAST addressable system capable of lockdown alert functionality and internet connectivity, and able to accommodate C-TEC's CAST-PRO combined fire detection and alarm devices, which the manufacturer describes as false alarm resistant and award-winning.

Installer's view

Wayne Riley, managing director of W R Fire & Security, said the company was very impressed with FastConvert and considered it extremely innovative in terms of what it can do. Against a full re-wire that would have added around £10,000 to the job, or converting the remaining zones into loops at an extra £3,000 to £4,000 plus a week's additional labour for two engineers, he called FastConvert the clear winner. He said it massively reduced installation time, site disruption and labour costs, and saved approximately £3,500 on the project.

Riley added that the installer rated the new CAST-PRO devices highly, describing them as far superior to other manufacturers' products because the sounder and VAD units and the multi-sensors are built into the heads, so separate sounder bases are not needed.

Reported by Ingrid Solberg, Wiring, enclosures and specification writer.