Automotive Accessories

Jeep Builder Creates Low-Cost Rear Portal Axle by Inverting the Differential

Astrid BerglundNovember 17, 20265 min read11 views

At a glance

  • A home-built setup pairs a Ford 9-inch housing with Humvee portal hubs and turns the diff upside down to correct driveline rotation.
  • Zeph Gage built a rear-only portal axle for a Jeep XJ using a flipped Ford 9-inch differential, Humvee geared hubs and custom fabrication. The setup is intended to add about six inches of clearance at roughly one-fifth the cost of a typical portal-axle pair.
Concept illustration of a rear axle with an inverted differential and compact portal gear hubs on a generic off-road SUV.

Portal axles are prized in hardcore off-roading because they lift the axle shafts and reduce hardware hanging below the chassis, but a typical pair can cost about $20,000. A Jeep XJ build by Zeph Gage takes a different route: it installs a portal only at the rear and uses adapted parts to cut the cost to roughly one-fifth of that figure.

Instead of relying on a conventional axle layout, portal axles place a set of gears behind each driven wheel. That lets the axle tubes sit higher and makes room for tall tires. The tradeoff is cost and complexity, especially when a vehicle was not factory-equipped with portals.

How the flipped differential works

Two-gear portal hubs, such as the Humvee units used here, reverse the rotation of the input shaft. To make that work with a Ford 9-inch axle, Gage mounted the differential upside down so the driveline turns in the correct direction. A Yukon Gear and Axle third member is then bolted to the housing.

The result is described as a budget high-pinion arrangement made from low-pinion parts that have simply been turned over. The build uses a Ford 9-inch axle housing, geared hubs from a Humvee and Jesse Haines Fabrication HMMWV portal adapters.

Clearance, travel and strength

The rear portal adds about six inches of clearance. It also retains full shock travel, a packaging challenge with portal axles, and is expected to reduce stress on the differential. That combination is intended to make the rear end tough without forcing the rest of the suspension into a compromise.

Why only the rear?

Fitting a portal axle only at the rear is a common trick in remote-control rock crawling. Keeping the front solid axle avoids the packaging constraints that arise when adding portals to a vehicle that never had them. Gage therefore does not have to limit shock travel to make room, and the ride height does not become absurdly tall.

The approach also has a practical obstacle-clearing benefit. The rear end can clear objects the front end has already steered around, reducing the chance of getting hung up.

Not a bolt-on kit

The conversion required substantial custom work. The build includes homemade brackets, custom-tapped plates and a two-piece brake rotor paired with a Ford Fusion caliper. The Fusion caliper was chosen partly because it has an integrated electric parking-brake solenoid and because it helps with clearance.

The finished XJ can drive over a five-gallon bucket and still have several inches of clearance to spare. Gage’s build is not an off-the-shelf solution, but it shows how adapted factory parts and careful fabrication can deliver portal-axle capability at a fraction of the usual price.

Reported by Astrid Berglund, Vehicle Cargo and Roof System Analyst.